Maintenance; General; Maintenance Schedule; General Inspection - Husqvarna LC 141LI Operator's Manual

General

WARNING! The user must only carry out the maintenance and service work described in this
!
Operator's Manual. More extensive work must be carried out by an authorized service workshop.
Prevent unintentional start during transport, maintenance or repair work by turning the safety key
to '0', removing the battery and waiting at least 5 seconds.
The life span of the machine can be reduced and the risk of accidents can increase if machine
maintenance is not carried out correctly and if service and/or repairs are not carried out
professionally. If you need further information please contact your nearest service workshop.
• Let your Husqvarna dealer regularly check the machine and make essential adjustments and repairs.
• Replace any damaged, worn or broken parts.
• Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated based on daily use of the machine, and may differ depending
on the rate of usage.
WARNING! Prevent unintentional start during transport, maintenance or repair work by turning the
!
safety key to '0', removing the battery and waiting at least 5 seconds.

General inspection

Cleaning
Make sure the immobilizer works*
Check that the machine's safety equipment is undamaged.
Make sure the on/off button is in working order and not defective.
Check that the battery is intact.
Check the battery's charge.
Check that the release buttons on the battery works and locks the battery
into the machine.
Check that the battery charger is intact and functional.
Check the connections between the battery and the machine and also
check the connection between battery and the battery charger.
Check the cutting attachment**. Never use blades that are dull, cracked or
damaged.
Make sure the cutting cover is not damaged and that there are no visible
defects such as cracks.*
Check the motor brake handle. Release the motor brake handle and make
sure the motor stop.
*See instructions in the section "Machine's safety equipment".
** See instructions in the section "Cutting equipment".
General inspection
• Check that nuts and screws are tight.
• Make sure no cables are pinched.
92 – English

MAINTENANCE

Before Weekly
starting maintenance
X
X
X
X
X
X
X
X
X
X
X
X
Monthly
maintenance
X