Optional Priority Scanning - Motorola maxtrac 300 User Manual

3.
4.
5.
6.
On Larry's MaxTrac 300, after programming desired channels, press the [Scan] button.
To turn off the [Scan], Larry just presses the scan button again.

Optional Priority Scanning

Using the [Up] or [Down] buttons, select the
channel you wish to add (or remove) from the user
scan list.
Pressing [Select] will toggle the channel on or off
your scan list.
The display will indicate if a channel is in the user
scan list by showing a vertical segment in the
upper left of the display.
Repeat steps 3 to 5. Once you have your desired
channels selected just press [Scan] and the display
should go back to normal. Now, you can press the
[Scan] button to start scanning. Another thing to
note is the User Scan channels will stay in the
radio until changed. Loss of power won't clear the
list.
The operator can also set Priority One and Priority Two
channels for the User Scan list which will be checked more
often than the other channels in the scan list. During the
procedure above, press and hold [Select] for 2 seconds and
the [Pri] led at the top of the display should blink. This
indicates you've set Priority One as shown in the first
7