Ositech comm Trumpcard Data/Fax Modem User's Manual And Reference page 47

Examples
ATSn
ATSn=x
ATSn?
T — Set Tone Dial as Default
Parameters:
Default:
Causes the modem to assume that all subsequent dial commands are
tone dialled. The user may omit the "T" from the dial string.
Vn — Result Code Form
Parameters
Default
Selects whether the modem returns long form or short form result codes.
All responses are ASCII values. Long-form (verbose) responses are
preceded and terminated with both carriage return and line feed control
characters. Short-form (numeric) responses are only terminated with a
carriage return control character (see Xn command).
Examples
ATV0
ATV1
Wn — Connect Message Control
Parameters
Default
This command controls which message(s) are reported upon connection.
These messages can also be reported in either numeric or verbose form.
For example, both 77 and PROTOCOL:LAP-M indicates that the error-
correction protocol is LAP-M. (See Xn command.)
Examples
ATW0
ATW1
ATW2
User's Guide and Reference
Establishes S-register n as the default register
Set S-register n to the value x
Reports the value of S-register n
none
none
0 or 1
1
Allows short-form (numeric) result codes to be sent.
Allows long-form (verbose) result codes to be sent.
0, 1, or 2
0
Upon connection report CONNECT XXXX only
Upon connection report CARRIER XXXX,
PROTOCOL XXXX and CONNECT XXXX
Upon connection report CONNECT XXXX only
Modem Command Reference
4 - 15