Operating The Trumpcard; Using At Commands - Ositech comm Trumpcard Data/Fax Modem User's Manual And Reference

Operating the Trumpcard

Using AT Commands

In order to communicate with the Modem, the Modem must be in
command mode. In addition, you must have your communications
software operating and communicating interactively with the Modem. The
Trumpcard will automatically be in command mode after you turn on your
computer.
Any commands you issue to the Trumpcard must be prefixed with AT (or
at). The only exception to the "AT" prefix rules are the re-execute (A/)
command and the escape code (initially +++).
It is not necessary that commands be entered after the "AT" sequence, but
you must send a carriage return [RETURN] or [ENTER] key at the end of
the command line.
The Trumpcard automatically senses the speed and data format of your
communications package provided it is set to one of the following formats:
• Speed: 110, 300, 600, 1200, 2400, 4800, 7200, 9600,
19200, 38400, 57600 or 115200
• Data Format
A command line may contain a single command or a series of commands.
You can separate multiple commands with spaces for readability if you
like. The "AT" prefix is only required once at the beginning of the
command line. The command line may contain up to 41 characters. You
can edit the command line using the backspace key and entering the new
command. (You will not be able to edit the "AT" prefix once you enter it. If
you begin to enter a command and change your mind, use the backspace
key to remove the command up to the "AT" prefix and press [ENTER]).
User's Guide and Reference
Data Bits
7
7
7 mark or space
8 even or odd or none
Parity
even or odd
none
Basic Modem Operation
Stop Bits
1 or 2
2
1 or 2
1 or 2
4 - 3