Result Codes - Ositech comm Trumpcard Data/Fax Modem User's Manual And Reference

Result Codes

NO DIAL TONE
BUSY
NO ANSWER
CONNECT XXXX
NO CARRIER
En — Command Echo
Parameters
Default
Controls the echo of characters received by the modem while the modem
is in the command mode. If both the modem and the software have echo
on, double characters will appear. If no characters appear, then both
character echoes are off.
Examples
ATE0
ATE1
Fn - Select Line Modulation (14400 only)
Parameters
Default
This command can be used to assure that a connection is made only at
the specified speed.
Examples
ATF0
ATF1
ATF2
User's Guide and Reference
If X2 or X4 is selected and 1 second of dial tone is
not detected within 5 seconds; or if W dial modifier
is used and 3 seconds of dial tone is not detected
within the time specified by S7
If busy is detected, and X3 or X4 is selected or if dial
modifier is used
If "@" dial modifier is used and 5 seconds of
silence is not detected within the time specified by
S7
If a connection is established
If a connection cannot be established, the abort
timer (register S7) expires; or a character is entered
during the handshake process
0 or 1
1
Inhibits the echoing of commands
Enables the echoing of commands
0 through 10, 13 through 19
0
Selects auto-detect mode (equivalent to N1
command)
Permit V.21 or Bell 103 connections only based on
ATBn setting.
Reserved
Modem Command Reference
4 - 9