2.
Connect the Ethernet interface cable to the 10BASE-T/100BASE-TX port.
3.
Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
4.
Turn on the main power switch of the machine.
1. Indicators
When 100BASE-TX or 10BASE-T is operating, the green LED is lit and the orange LED flashes. If the
machine is not connected to the network, both LEDs are turned off.
• For details about how to turn on the main power switch, see "Turning On/Off the Power".
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
• page 74 "Turning On/Off the Power"
Connecting to the USB (Type B) Interface
This section describes how to connect the USB2.0 (Type B) interface cable to the USB2.0 port.
CFL007
1
CFL014
Connecting the Machine
91