Programmable Tig Start Parameters - Miller DYNASTY 350 Owner's Manual

6-2.

Programmable TIG Start Parameters

.
Each memory and polarity selection has their own programmable parameters.
Changing Programmable TIG Start Amperage
A.
STRT
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
To adjust TIG Start Amperage, press Am-
B. Changing Programmable Start Time
TIME
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
Changing Programmable TIG Start Polarity (Dynasty Models Only)
C.
1 Amperage Switch Pad
2 Encoder Control
3 Amps Meter
20A
perage switch pad. Switch pad LED turns
on. If necessary, press Amperage switch
pad to scroll through the programmable
TIG start parameters until the current Start
10m
To adjust Programmable Start Time, press
Amperage switch pad. The current Start
Time is displayed on the amps meter, and
En
POL
To adjust TIG Start Polarity, press Amper-
age switch pad. Switch pad LED turns on.
The current Start Polarity, [POL][En] or
3
Amperage is displayed on the amps meter.
The TIG start amperage can be adjusted
(see Section 5-15) by turning the Encoder
control.
3
1
can be adjusted by turning the Encoder
control (see Section 5-15).
3
[POL][EP] is displayed on meters, and can
be changed (see Section 5-15) by turning
the Encoder control.
2
1
2
2
1
OM-216 869 Page 57