Table of Contents
Advertisement
14
4
TxD
5
GND
6
RxD
7
RTS
8
CTS
9
Not Used
COM1 [RS-485 2/4 W] Port , COM3[RS485], COM3[RS232] Port
Pinout of DE9S (female) connector
Pin#
Symbol
COM1 [RS485 2W]
1
Rx-
RS485 Receive
2
Rx+
RS485 Receive
3
Tx-
RS485 Transmit
4
Tx+
RS485 Transmit
5
GND
6
Data-
7
TxD
RS232 Transmit
8
RxD
RS232 Receive
9
Data+
Connecting to the Panel PC Using Ethernet - Windows CE
The Ivory Series comes equipped with a 10/100BaseT Ethernet port. By default, the Ivory Series' Ethernet port is
set to get an IP address from a DHCP server.
4
To change the static IP address:
1.
From the Windows CE.net desktop, click the Start button.
2.
Click Settings.
3.
Click Network and Dial-up Connections.
4.
Double-click CS89501.
5.
Select the IP Address tab.
6.
Click the Specify an IP address option button.
7.
Enter an IP Address and Subnet Mask. Make sure that the IP Address and Subnet mask are
consistent with the IP addresses that the Panel PC will be connected to.
8.
Enter a Default Gateway if needed.
9.
Select the Name Servers tab.
10. If required, enter the IP addresses of the Primary and Secondary Domain Name Service
servers.
11. If required, enter the IP addresses of the Primary and Secondary Windows Internet Naming
Service servers.
12. Click the OK button. Then close the Network Connections window.
1010-1010, Rev 02
Transmit Data
Signal Ground
Receive Data
Ready to send output
Clear to send input
COM1 [RS485 4W]
Data -
Data +
Ivory Series Installation & Operation Manual
COM3[RS485 2w]
RX -
RX +
TX -
TX +
Signal Ground
Data -
Data +
COM3[RS232]
Transmit Data
Receive Data
Advertisement
Table of Contents
