Toro TDC+ Startup Manual page 13

Assigning Control Module Serial Port & Completing Setup
This procedure will designate which serial communication port on the TDC+ Control Module
will talk to the Two-Wire Gateway (output boards). On a TDC+, it is recommended that you
designate and utilize the "front" serial port, because computer programming occurs through the
"back port".
8. Choose the Advanced tab.
9. Under Station Type / port assignments: For "Send Toro 2-Wire commands to:" select Serial
Port 1 (front port).
10. Under "Station Types allowed after 96," select Toro 2-wire.
11. SAVE all Changes and Close Special Data Window.
TDC+ QUICK START GUIDE Page 13 / 20