Fireplace Installation - Dimplex DF2550-EU Owner's Manual

Site Selection and Preparation
this section provides instructions
for selecting a location and
preparing the site to install the
fireplace into your Dimplex mantel
surround.
①
select a suitable location that
is not susceptible to moisture and
is away from drapes, furniture and
high traffic.
②
For ease of electrical hook
up you may wish to locate the
fireplace near an existing outlet
(refer to notE 1).

Fireplace Installation

①
Install the fireplace assembly
into the mantel (refer to mantel
assembly instructions) and fix
mantel according to mantel
assembly instructions.
!
NOTE 1: A 10 Amp, 240 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when
the heater is operating.
③
store the fireplace in a safe
dry and dust free location.
!
NOTE: The dimensions of the
fireplace are 661 mm wide x
480 mm high x 223 mm deep.
the fireplace does not require
any additional venting.
④
The heater must not be
located immediately below a
socket outlet.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
!
IMPORTANT: If not using a
Dimplex mantel, the fireplace
must be installed in an
enclosure with the following
minimum internal/opening
dimensions (Figure 1).
7