Table of Contents
Advertisement
ADJUSTING THE BASE PLATE FOR BEVEL
CUTTING (Fig. 2)
1. Use the hex key to loosen the two hex
screws located on the underside of the tool.
2. Move the base plate back slightly and tilt it
to the desired angle, between 0 and 45° left
or right, referring to the scale marked on the
base bracket.
3. Move the plate or guide roller forward until
the back of the blade rests in the groove of the guide roller.
4. Securely tighten the hex screws.
Accurate work requires a trial cut. Measure the work after cutting and reset the angle
setting until the correct setting is achieved.
DUST EXTRACTION (Fig. 3)
1. Insert the vacuum adaptor tube onto the
groove in the dust port.
2. Rotate the vacuum adaptor tube until the
tube is secured on the tool.
WARNING!
•
Always unplug the saw from the power source before making any adjustments or attaching
accessories.
•
Do not use a dust extraction system or a vacuum cleaner when cutting metal. Sparks may ignite
residual wood dust.
Fig. 2
Plate
Fig. 3
Guide Roller
9
Advertisement
Table of Contents
