Table of Contents
Advertisement
8
model no. 054-8289-8
ASSEMBLY INSTRUCTIONS
INSTALLING THE SAW BLADE (Fig. 1)
1. Unplug the jigsaw from the power supply.
2. Turn the tool upside down and open the
protection guard by pulling it downward.
3. Loosen the hex screws on the blade clamp
with the hex key, which is stored at the base
of the power cord.
4. Insert the blade into the locating groove in
the blade clamp. The back of the blade must
rest in the groove in the guide roller.
5. Tighten the hex screws to lock the blade. Pull on the blade to check that it is securely
locked in place.
REMOVING THE SAW BLADE (Fig. 1)
1. Unplug the jigsaw from the power supply.
2. Open the protection guard by pulling it downward.
3. Turn the tool upside down and loosen the hex screws on the blade clamp with the hex
key.
4. Remove the blade by pulling it out from the base of the jigsaw.
NOTE:
•
If the blade cannot rest in the groove of the blade clamp, check the section ADJUSTING THE BASE PLATE FOR
BEVEL CUTTING below.
•
Use only with "T" and "U" shank jigsaw blades.
CAUTION!
•
When changing the blade, always wear protective gloves. The sharp edge of the blade can cause
personal injury. The blade can be very hot after working.
•
Allow the blade to cool after use. The blade can be dangerously hot.
WARNING!
•
Check to see if the blade is correctly fastened. An incorrect or insecurely fastened blade can
become loose during operation and cause a hazard.
•
Always ensure that the tool is turned OFF and unplugged from the power supply before making any
adjustments and installing any attachments.
Fig. 1
Protection
guard
Advertisement
Table of Contents
