Table of Contents
Advertisement
STRAIGHT CUTTING (Fig. 6)
Mark the cut. Position the saw so that the
blade is in line with the desired cut. Mark the
position of the side edge of the saw base and
then clamp the straight edge on the mark,
parallel to the cut. Make the cut from one
direction only. Never cut halfway and then
complete the cut from the opposite end.
GENERAL CUTTING
1. Firmly clamp the workpiece in place.
2. Use the appropriate type and size of blade for the workpiece.
3. Check the clearance behind the workpiece and assure that the blade will not impact
another surface.
4. Clearly mark the line of cut.
5. Hold the saw firmly. Make sure that your hand is on the insulated gripping areas only.
6. Rest the base plate on the workpiece so that the blade is not in contact with the
workpiece
7. Turn on the jigsaw and bring it to the maximum desired cutting speed before applying
the blade to the workpiece.
8. Slowly move the jig saw into the workpiece.
9. Do not force the tool. Keep the base plate flat against the workpiece while cutting. Use
only enough steady pressure on the blade to keep the saw cutting.
10. Reduce pressure as the blade comes to the end of the cut.
11. Allow the saw to come to a complete stop before removing the blade from the workpiece.
12. If sawing fibreglass, plaster, wallboard, or spackling compound, clean the saw motor
vents frequently with a vacuum or compressed air. Always wear safety goggles when
cleaning tools using compressed air. These materials are highly abrasive and may
accelerate the wear on motor bearings and brushes.
NOTE:
Always apply a steady, firm, downward pressure on the front of the saw as you cut. This will keep the saw blade from
jumping out of the workpiece.
WARNING!
•
Before attempting to use this tool, become familiar with all of its operating features and safety
requirements.
•
Always securely and support the workpiece. Always maintain proper control of the jigsaw. Failure to
clamp and support the workpiece and loss of control of the saw could result in serious injury.
Fig. 6
11
Advertisement
Table of Contents
