Supporting The Motorcycle; Front Wheel - Yamaha TT-R50E Owner's Manual

Periodic maintenance and adjustment

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
To service the front wheel
1. Stabilize the rear of the motorcy-
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
2. Raise the front wheel off the
ground by using a motorcycle
7
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
frame in front of the rear wheel or under
each side of the swingarm.
EAU24351

Front wheel

To remove the front wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Remove the front fork leg guard
from each front fork leg by remov-
ing the bolts.
1. Front fork leg guard
2. Bolt
2. Disconnect the brake cable at the
wheel by removing the brake lever
free play adjusting nut at the brake
camshaft lever, then remove the
cable from the brake camshaft le-
ver.
7-29
EAU24361
EAU56364
EWA10822