Rear Wheel - Yamaha TT-R50E Owner's Manual

Periodic maintenance and adjustment
Tightening torque:
Axle nut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
5. Connect the brake cable to the
brake camshaft lever, and then in-
stall the brake lever free play ad-
justing nut on the brake cable.
TIP
If the spring was removed, install it
onto the brake cable with its smaller di-
ameter end facing down.
1
2
7
1. Brake cable
2. Spring
6. Adjust the brake lever free play.
(See page 7-17.)
7. While applying the front brake,
push down hard on the handlebar
several times to check for proper
fork operation.
8. Install each front fork leg guard by
installing the bolts.

Rear wheel

To remove the rear wheel
WARNING
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2
1
1. Axle nut
2. Washer
3. Drive chain slack adjusting nut
4. Locknut
5. Drive chain puller
2. Remove the brake pedal free play
adjusting nut, and then discon-
nect the brake rod from the brake
camshaft lever.
7-31
EAU25081
EAU56732
EWA10822
4
3
5