Yamaha TT-R50E Owner's Manual page 75

Periodic maintenance and adjustment
1
3
1. Brake pedal free play adjusting nut
2. Brake rod
3. Brake camshaft lever
3. Fully loosen the locknut and drive
chain slack adjusting nut on each
end of the swingarm.
4. Lift the rear wheel off the ground
according to the procedure on
page 7-29.
5. Remove the axle nut, washer and
the drive chain puller at the left
side, then pull the wheel axle out
together with the drive chain puller
from the right side.
1. Wheel axle
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
2
1
7-32
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
7. Remove the wheel.
To install the rear wheel
1. Install the drive chain onto the rear
sprocket, lift the rear wheel off the
ground, and then install the wheel
by inserting the wheel axle togeth-
er with the drive chain puller from
the right side.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
swingarm.
1. Slot
2. Retainer
2. Install the drive chain puller at the
left side, washer and axle nut.
7