Checking The Front Fork Legs - Yamaha YZ250F 2016 Owner's Service Manual

5. Remove:
• Base valve "1"
(from the damper assembly)
TIP
Hold the damper assembly with the cap bolt
ring wrench "2" and use the cap bolt wrench "3"
to remove the base valve.
Cap bolt wrench
90890-01500
YM-01500
Cap bolt ring wrench
90890-01501
YM-01501
3
2

CHECKING THE FRONT FORK LEGS

EAS1SM9166
1. Check:
• Inner tube
Scratches  Repair or replace.
Use #1000 grit wet sandpaper.
Damaged oil lock piece  Replace.
• Outer tube
Out of specification  Replace.
Use the dial gauge "1".
Inner tube bending limit
0.2 mm (0.01 in)
TIP
The bending value is shown by one half of the
dial gauge reading.
EWA13650
WARNING
Do not attempt to straighten a bent inner
tube as this may dangerously weaken it.
1
2. Check:
• Outer tube
Scratches/wear/damage  Replace.
3. Measure:
• Fork spring free length "a"
Out of specification  Replace.
Limit
492.0 mm (19.37 in)
4. Check:
• Damper rod "1"
Bend/damage  Replace.
• Damper rod "2"
Wear/damage  Replace.
ECA1DX1010
NOTICE
• The front fork leg has a built-in damper ad-
justing rod and a very sophisticated inter-
nal construction, which are particularly
sensitive to foreign material.
• When disassembling and assembling the
front fork leg, do not allow any foreign ma-
terial to enter the front fork.
4-40
FRONT FORK