INSTALLING THE CROSSOVER
Step 1: Find a location for the crossover away from any factory or after
market electrical wires. It is recommended to mount the passive
crossover close to the amplifier. In the event you decide to upgrade
and bi-amplify the system, mounting the passive crossover close to the
amplifier would simplify the installation upgrade.
Step 2: Remove top cover of crossover housing. Don't lose it.
Step 3: Mark with a marking pen the two mounting holes.
Step 4: Remove crossover and pre-drill mounting holes using a 1/8" drill bit.
WARNING:
Step 5: Mount the crossover using the supplied #8 screws.
Step 6: Connect the wires. Make sure the speaker wires for the mid/woofer go to the
woofer
Be
sure
polarity of the tweeter may be necessary for optimum sound quality.
Step 7: Re-install the crossover cover.
© 2007 directed electronics—all rights reserved
Check for clearance of window mechanisms and electrical wires
BEFORE you drill.
output
and
to
observe
the
tweeter
the
correct
to
the
tweeter
polarity.
Changing
output.
the
7