Installing The Tweeters - Orion HCCA 5.2 Owner's Manual

INSTALLING THE TWEETERS

SURFACE MOUNTING
Step : Determine the tweeter mounting location, then route the wires from the
crossover to the tweeter location.
Step 2: Place the provided template or tweeter cup against the panel and mark the
two holes at the rear of the housing.
Step 3: Drill the smaller holes using a /8" drill bit. These are the mounting screw holes.
WARNING:
Step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet
and route the speaker wire from the crossover through the grommet.
Step 5: After removing the surface mount tweeter assembly trim ring, route the
tweeter wires through the larger hole in the housing and connect to the
speaker wires from the crossover. (See Figure 4.)
Step 6: Insert the excess speaker wire into the hole and position the housing so the
housing will not pinch the wires after final mounting.
Step 7: Attach the housing using the supplied screws of the correct length for a solid
mount.
Step 8: Insert the tweeter into the housing and attach the surface mount trim ring.
SURFACE
MOUNT
TRIM RING
© 2007 directed electronics—all rights reserved
Step 8:
the grille in the installationhole. Align the mounting screw
holes and drive in the four mounting screws.
Check for clearance of window mechanisms and electrical
wires BEFORE you drill.
MOUNTING SCREWS
TWEETER
TWEETER
Mount the speaker. Place the speaker and the and
SURFACE MOUNT HOUSING
WIRE PANEL WIRING HARNESS
5