Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Orion HCCA 5.2
Summary of Contents for Orion HCCA 5.2
- Page 1 HCCA 5.2 HCCA 6.2...
-
Page 2: Table Of Contents
The components are available in a standard 5 /4" and 6-/2” sizes to fit most applications. We at Orion strive to give you all the latest up to date information about this product. What we can’t give you in this manual is personal installation or technical experience. -
Page 3: What's In The Box
Authorized Orion Dealer for technical assistance. Orion dealers are trained professionals dedicated to extracting the maximum performance out of your Orion system. If you decide to install this speaker system yourself, please read the entire installation section before starting your installation. -
Page 4: Tools Of The Trade
Listed are the majority of the tools required to perform the installation. Having the proper tools will make the installation much easier. It is very difficult when you get half way through the installation and discover that you require a specific tool to get yourself through a particular part of the installation. -
Page 5: Door Mounting
When checking for possible speaker locations in the doors, check the operation of the window and all assemblies. There is also a stabilizer stop bar in between the door and the door jamb. This bar prevents the door from opening too far. Many shade tree installers overlook this and check for clearance only when the door is fully open. -
Page 6: Installing The Tweeters
Step 8: the grille in the installationhole. Align the mounting screw holes and drive in the four mounting screws. INSTALLING THE TWEETERS SURFACE MOUNTING Step : Determine the tweeter mounting location, then route the wires from the crossover to the tweeter location. Step 2: Place the provided template or tweeter cup against the panel and mark the two holes at the rear of the housing. -
Page 7: Full Flush Mounting
Step : Determine where the tweeter will be mounted. Make sure there is a flat area large enough for the tweeter and no obstructions behind the area. Step 2: Using supplied template mark with a pen the hole needed for the tweeter. Step 3: Be sure the hole is large enough for the tweeter housing. -
Page 8: Installing The Crossover
Step 1: Find a location for the crossover away from any factory or after market electrical wires. It is recommended to mount the passive crossover close to the amplifier. In the event you decide to upgrade and bi-amplify the system, mounting the passive crossover close to the amplifier would simplify the installation upgrade. Step 2: Remove top cover of crossover housing. Don’t lose it. Step 3: Mark with a marking pen the two mounting holes. - Page 9 NOTE: The crossover has a parallel and a bi-wire/bi-amp input. To access these settings remove the top cover of the crossover. This is accomplished with a small flat head screw driver. There is a small notch just to the left of the output plug on the crossover.
- Page 10 Bi-Amp Wiring input Note: The tweeter positive is the wire marked with the stripe © 2007 directed electronics—all rights reserved To subwoofer output To tweeter...
-
Page 11: Specifications
Conex woven to spider with 2dB high pass, 6dB low pass, tweeter level adjust- ments, multi stage tweeter protection, and mid/mid-bass zobel circuit. 37206 37207 HCCA 5.2 HCCA 6.2 4 ohms 4 ohms 50/00 60/20 75Hz - 20kHz 55Hz - 20kHz... - Page 12 Limited Warrantymay not apply to you. This Limited Warranty gives you specific legal rights, and you may have other rights which vary from state to state. © 2007 Directed Electronics. All rights reserved. For more information on Orion products please visit www.orioncaraudio.com 920-0033 Rev 02-07 G37206.07 2007-09...