Full Flush Mounting - Orion HCCA 5.2 Owner's Manual

FULL FLUSH MOUNTING

Step : Determine where the tweeter will be mounted. Make sure there is a flat
area large enough for the tweeter and no obstructions behind the area.
Step 2: Using supplied template mark with a pen the hole needed for the tweeter.
Step 3: Be sure the hole is large enough for the tweeter housing.
Step 4: Cut the hole for the tweeter. When using factory locations, this
step can be skipped. A hole can be cut either with a pair of metal tin
snips or a 2" hole saw for soft materials or 2-/8" hole saw for hard materials.
WARNING:
Step 5: Install tweeter in flush mount housing.
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Install tweeter and housing in the hole cut for mounting, so that the
trim ring is flat with the front of the surface.
Step 8: Use the supplied pressure ring to secure the housing to the surface.
SURFACE
TRIM RING
6
Check for clearance of window mechanisms and electrical wires
BEFORE you drill.
FLUSH MOUNT
TWEETER
ASSEMBLY
MOUNTING
MOUNT SCREWS
TWEETER
SURFACE
MOUNT
HOUSING
TWEETER WIRE PANEL
PRESSURE
RING
WIRING HARNESS
© 2007 directed electronics—all rights reserved