Installing The Tweeters - Orion HCCA1002 Owner's Manual

InsTallInG THe TWeeTeRs

SURFACE MOUNTING
step 1: Determine the tweeter mounting location, then route the wires from the
crossover to the tweeter location .
step 2: Place the provided template or tweeter cup against the panel and mark the
two holes at the rear of the housing .
step 3: Drill the smaller holes using a 1/8" drill bit . These are the mounting screw
holes .
WARNING: Check
wires befoRe you drill .
step 4: Drill the larger off-center hole using a 3/8" drill bit, insert a grommet
and route the speaker wire from the crossover through the grommet .
step 5: after removing the surface mount tweeter assembly trim ring, route the
tweeter wires through the larger hole in the housing and connect to the
speaker wires from the crossover .
step 6: Insert the excess speaker wire into the hole and position the housing so the
housing will not pinch the wires after final mounting .
step 7: attach the housing using the supplied screws of the correct length for a solid
mount .
step 8: Insert the tweeter into the housing and attach the surface mount trim ring .
SURFACE
MOUNT
TRIM RING
Figure 1
Figura 1
Abbildung 1
4
for clearance
MOUNTING SCREWS
TWEETER
TWEETER WIRE
of window mechanisms
SURFACE MOUNT HOUSING
PANEL
© 2010 directed electronics—all rights reserved
and electrical
WIRING HARNESS