Canon MX720 Series Online Manual page 183

1. Detected Access Points:
The signal strength from the access point, encryption type, name of access point, and the
radio channel can be confirmed.
Important
If you connect to a network that is not protected with security measures, there is a risk
of disclosing data such as your personal information to a third party.
Note
Signal strength is displayed as follows.
: Good
: Fair
: Poor
Type of encryption is displayed as follows.
Blank: No encryption
WEP: WEP is set
WPA: WPA is set
WPA2: WPA2 is set
2. Refresh
Click to update the list of access points when your target access point is not detected.
If the target access point is set to a closed network (the stealth mode), click Cancel to return
to the previous screen and enter the network name (SSID) in Network (SSID).
Note
Make sure that the access point is turned on.
3. Set
Click to set the network name (SSID) in Network (SSID): on the Wireless LAN sheet.
Note
The WEP Details screen, the WPA Details screen, or the WPA2 Details screen
appears if the selected access point is encrypted. In this case, configure the details to
use the same encryption settings set to the access point.
Access points that cannot be used by this machine (including those configured to use
different encryption methods) are displayed grayed out and cannot be configured.