Indicator Lights And Warning Lights - Yamaha MT07 Owner's Manual

Indicator lights and warning
lights
1 2 3 4 5
1. Left turn signal indicator light "
2. Oil pressure warning light "
3. Coolant temperature warning light "
4. Engine trouble warning light "
5. Anti-lock Brake System (ABS) warning
light " " (for ABS models)
ABS
6. Immobilizer system indicator light "
7. High beam indicator light "
8. Neutral indicator light " "
9. Right turn signal indicator light "
Turn signal indicator lights "
and " "
Each indicator light will flash when its
corresponding turn signal lights are
flashing.
EAU49398
Neutral indicator light "
This indicator light comes on when the
transmission is in the neutral position.
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Oil pressure warning light "
6 7 8 9
This warning light comes on if the en-
"
gine oil pressure is low.
"
The electrical circuit of the warning
"
light can be checked by turning the key
"
to "ON". The warning light should
come on again after going off briefly,
and then remain on until the engine is
"
" started.
If the warning light does not come on
"
initially when the key is turned to "ON",
have a Yamaha dealer check the elec-
EAU11032
trical circuit.
"
NOTICE
If the warning light comes on when
the engine is running, stop the en-
gine immediately and check oil level.
Instrument and control functions
If the oil level is below the minimum
EAU11061
"
level, add sufficient oil of the recom-
mended type to raise it up to the cor-
rect level. If the oil pressure warning
light remains on even if the oil level
EAU11081
" is correct, immediately turn the en-
gine off and have a Yamaha dealer
check the vehicle.
TIP
EAU59962 If the warning light does not go off after
"
starting the engine, check the engine
oil level and add oil if necessary. (See
page 6-9.)
If the warning light remains on after
adding engine oil, have a Yamaha
dealer check the vehicle.
Coolant temperature warning
light "
This warning light comes on if the en-
gine overheats. If this occurs, stop the
engine immediately and allow the en-
ECA21210
gine to cool.
3-4
EAU11447
"
3