Yamaha DRAG STAR XVS1100A Owner's Manual page 18

INSTRUMENT AND CONTROL FUNCTIONS
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Oil level warning light "
This warning light comes on when the
3
engine oil level is low.
The electrical circuit of the warning light
can be checked by turning the key to
"ON".
If the warning light does not come on
for a few seconds, then go off, have a
Yamaha dealer check the electrical cir-
cuit.
NOTE:
Even if the oil level is sufficient, the
warning light may flicker when riding on
a slope or during sudden acceleration
or deceleration, but this is not a mal-
function.
EAU11080
" Engine trouble warning light "
This warning light comes on or flashes
when an electrical circuit monitoring the
engine is defective. When this occurs,
have a Yamaha dealer check the self-
diagnosis system.
EAU11120
"
The electrical circuit of the warning light
can be checked by turning the key to
"ON". If the warning light does not come
on for a few seconds, then go off, have
a Yamaha dealer check the electrical
circuit.
Immobilizer system indicator light
" "
The electrical circuit of the indicator
light can be checked by turning the key
to "ON".
If the indicator light does not come on
for a few seconds, then go off, have a
Yamaha dealer check the electrical cir-
cuit.
When the key is turned to "OFF" and 30
seconds have passed, the indicator
light will start flashing indicating the im-
mobilizer system is enabled. After 24
EAU11500 hours have passed, the indicator light
"
will stop flashing, however the immobi-
lizer system is still enabled.
NOTE:
This model is also equipped with a self-
diagnosis device for the immobilizer
system. If the immobilizer system is de-
fective, the indicator light will start flash-
ing a pattern when the key is turned to
"ON". When this occurs, have a
Yamaha dealer check the self-diagno-
sis system. However, if the indicator
light slowly flashes five times, and then
EAU27020 quickly flashes two times repeatedly,
this error could be caused by signal in-
terference. If this occurs, try the follow-
ing.
1. Use the code re-registering key to
NOTE:
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
3-4
start the engine.