Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific BAR206 User Manual

1. °C / °F: Select temperature unit
2. RESET: Reset unit to default settings
3. EU / UK: Select the nearest radio signal (BAR206
only)
REMOTE SENSOR (FIG 3)
2
1
3
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG 2).
3. Press RESET after each battery change.
LOCATION
Clock / alarm and indoor
temperature area
Outdoor temperature area

REMOTE SENSOR

The main unit can collect data from up to 3 sensors.
4
To set up the sensor:
5
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
3
MEANING
Main unit batteries low
Sensor batteries low