Replacing A Turn Signal Light Bulb; Front Wheel - Yamaha FAZER FZS1000 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1. Screw
6
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
CAUTION:
Do not overtighten the screw, other-
wise the lens may break.
EAU24201

Front wheel

To remove the front wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Place the motorcycle on the cen-
terstand.
2. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
ECA11190
1. Wheel axle
2. Front wheel axle pinch bolt
6-34
EAU24360 3. Remove the brake hose holder on
each side by removing the bolts.
4. Remove the brake caliper on each
EAU24470
side by removing the bolts.
EWA10820
1. Bolt
2. Brake hose holder
3. Bolt
4. Brake caliper
CAUTION:
Do not apply the brake after the
brake calipers have been removed,
otherwise the brake pads will be
forced shut.
5. Pull the wheel axle out, and then
remove the wheel.
ECA11050