Toro 74310 Setup Instructions page 6

Figure 12
1. Lift points on each side of the seat
Important: Ensure the mower deck is in the
upright position before raising the front of the
machine.
13. Raise up the front of the machine, just enough to
remove and discard the deck support from under the
rear deck rollers.
14. Lower the machine to the ground.
15. Lift the front of the hopper up.
16. Using the hoist, lift the machine at the locations shown
in Figure 9 and Figure
17. Remove the crate from under the machine.
18. Lower the machine to the ground.
19. While supporting the mower deck, remove and discard
the 2 side struts, mounting brackets, and their hardware
on both sides of the seat
20. Remove and discard the strut located between the front
deck-support pins (Figure
12.
(Figure 13).
13).
1. Deck-support pin
2. Strut between the
deck-support pins
21. With the deck locking pins pulled out in the unlock
position, carefully lower the deck
1. Deck-lift handle
2. Rotate the deck locking
pin toward the rear and
pull outward to unlock
22. Push the deck-locking pins inward and rotate them
forward to securely lock the deck in the lowered
position.
6
Figure 13
3. Side-strut hardware
(Figure 14).
Figure 14
3. Push the deck locking pin
in and rotate toward the
front to lock