Toro 02750 Operator's Manual page 52

1.52 MAINTENANCE 1.52
Daily And Before Use continued
Check fasteners: Check that all nuts, bolts and
pins are secured correctly in place and in good
condition.
Check safety devices:
WARNING - PREVENT ACCIDENTS: Ensure
that all safety guards, shields and protective
devices are securely in place and in good work-
ing order.
Check tyres: Examine the condition of the tyres
and check that inflation pressures are correctly set,
refer to SPECIFICATIONS.
WARNING - PREVENT ACCIDENTS: Ensure
that damaged tyres are replaced. Ensure that
tyre tread depths comply with road traffic
regulations.
Grease all rear axle components including the cen-
tre axle beam pivot pin, both steering yokes, track
rod ball joints and steering cylinder ball joints,
refer to EVERY 50 HOURS, GREASE PIVOT
POINTS.
Check cutterheads: Examine the condition of
the cutting cylinders and bottom blades. Adjust as
necessary, refer to CUTTERHEAD CYLINDER
TO BOTTOM BLADE ADJUSTMENT.
Grease all cutterhead rollers with a good quality
medium grade grease and ensure that sufficient
grease is injected such that clean grease is seen to
escape from the roller end cap, refer to EVERY 50
HOURS.
If no grease can be seen escaping from the roller
end cap it can be assumed that the rear seal has
failed, resulting in the roller shell being filled with
grease.
Note: Care should be taken if an industrial
power greaser is used as this may result in dam-
age to the bearing sealing arrangement.
Check forward/reverse travel pedal action: With
the engine switched 'off', operate the forward
and reverse travel pedals through the full range of
articulation and ensure that the mechanism returns
freely to the neutral position.