Stopping The Engine; Unblocking The Cutting Cylinders - Toro 02750 Operator's Manual

1.42

Stopping The Engine

To stop the engine: Turn the ignition key to
position '0'.
WARNING: PREVENT ACCIDENTS - If the
engine fails to stop when the ignition key is
turned to 'O' operate the engine stop lever in a
forward direction. Keep hands clear of moving
objects and hot engine parts whilst the engine is
running.
Unblocking Cutting Cylinders
WARNING: PREVENT ACCIDENTS - Before attempting to clear any blockage from the cutting
cylinders on this machine ensure all of the following:
- Stop the machine on level ground.
- Apply the parking brake and disengage all drives.
- Lower the cutting units to the ground or securely lock in the designated transport positions.
- Stop the engine and remove the ignition key to isolate all power sources and check that they are
stopped.
- Release all stored energy devices.
- Check that all moving parts are stationary.
NEVER ATTEMPT TO ROTATE THE CUTTING CYLINDERS BY HAND as there may be some re-
sidual pressure in the hydraulic system which could cause injury through sudden movement of the cylinder(s)
when the blockage is released.
Always wear protective gloves and use a suitable strong wooden instrument. Ensure that this will fit between
the blades and through the cylinder and is long enough to provide sufficient leverage to release the blockage
and any residual hydraulic system pressure by rotating or rocking the cylinder. Make sure that the wooden
instrument is properly supported in the cylinder and avoid the use of excessive force to prevent damage.
Only when the cylinder has a degree of free movement should the source of the blockage be removed. Ensure
that the wooden instrument is also removed before restarting the power source.
If the cylinder requires readjustment or repair, refer to MAINTENANCE - CUTTERHEADS.
OPERATING THE MOWER
O
I
II
III
1
1. Engine RUN position
2
1. Engine STOP position
1.42