Toro 03180 Operator's Manual page 7

6
Installing the Fixed Plate Kit
(Optional)
Parts needed for this procedure:
1 Fixed plate kit (not included)
Procedure
1. Remove the nuts and washers securing the lift links to
the cutting unit side plate and carrier frame (Figure 10).
1. Nuts
2. Using the number 2 holes, insert a fixed plate onto the
bolts and secure with the nuts removed. The number
1 holes are to be positioned toward the front. Do not
reuse the washers.
Note: Number 1 is a less aggressive setting and
number 3 is a more aggressive setting.
Figure 9
2. Washers
1. Nuts
3. Loosen the locknuts securing the height-of-cut brackets
to the cutting unit side plates (Figure 11).
1. Height-of-cut bracket
2. Locknut
4. Remove the height-of-cut brackets and the roller from
the cutting unit.
5. Repeat the procedure on the remaining cutting units.
7
Figure 10
2. Fixed plate
Figure 11
3. Adjusting screw