Setup; Installing The Handle - Toro 20332 Operator's Manual

131-0894
Traction Adjustment
1. Attention; read the Operator's Manual—1) Loosen the
knob by turning it counterclockwise; 2) Pull the cable(s)
away from the engine to decrease the traction, or push
the cable(s) toward the engine to increase the traction; 3)
Tighten the knob by turning it clockwise.
131–4514
1. Warning—read the Operator's Manual.
2. Cutting/dismemberment hazard of hand or foot, mower
blade—stay away from moving parts; keep all guards and
shields in place.
3. Cutting/dismemberment hazard of hand or foot, mower
blade—disconnect the spark-plug wire and read the
instructions before servicing or performing maintenance.
4. Thrown object hazard—keep bystanders a safe distance
from the machine; stop the engine before leaving the
operating position; pick up any debris before mowing.
5. Cutting/dismemberment hazard of hand or foot, mower
blade—do not operate up and down slopes; operate side to
side on slopes; look behind you when backing up.

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine
Important: Route the cables to the outside of the
handle knobs as you install the handle.
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1 (Figure
5
Figure 3
3).
(Figure 3).