Toro Recycler 20332 Operator's Manual
Toro Recycler 20332 Operator's Manual

Toro Recycler 20332 Operator's Manual

22in lawn mower
Hide thumbs Also See for Recycler 20332:

Advertisement

22in Recycler
Model No. 20332—Serial No. 402082000 and Up

Introduction

This rotary-blade, walk-behind lawn mower is intended
to be used by residential homeowners. It is designed
primarily for cutting grass on well-maintained lawns
on residential properties. It is not designed for cutting
brush or for agricultural uses.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid
injury and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Important:
With your mobile device, you can
scan the QR code on the serial number decal (if
equipped) to access warranty, parts, and other
product information.
1. Model and serial number location
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety-alert symbol
(Figure
2), which signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Figure 1
Figure 1
Register at www.Toro.com.
Lawn Mower
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
This product contains a chemical
or chemicals known to the State of
California to cause cancer, birth defects,
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
It is a violation of California Public Resource Code
Section 4442 or 4443 to use or operate the engine on
any forest-covered, brush-covered, or grass-covered
land unless the engine is equipped with a spark
arrester, as defined in Section 4442, maintained in
effective working order or the engine is constructed,
equipped, and maintained for the prevention of fire.
The enclosed Engine Owner's Manual is
g226621
supplied for information regarding the US
Environmental Protection Agency (EPA) and
the California Emission Control Regulation of
emission systems, maintenance, and warranty.
Replacements may be ordered through the engine
manufacturer.
Gross or Net Torque: The gross or net torque
of this engine was laboratory rated by the engine
manufacturer in accordance with the Society of
Automotive Engineers (SAE) J1940 or J2723. As
configured to meet safety, emission, and operating
requirements, the actual engine torque on this class
of mower will be significantly lower. Please refer to
the engine manufacturer's information included with
the machine.
Form No. 3418-785 Rev A
Operator's Manual
Figure 2
Safety-alert symbol
WARNING
CALIFORNIA
Proposition 65 Warning
or reproductive harm.
Original Instructions (EN)
All Rights Reserved *3418-785* A
Printed in Mexico
g000502

Advertisement

Table of Contents
loading

Summary of Contents for Toro Recycler 20332

  • Page 1: Introduction

    Whenever you need service, genuine Toro parts, or or chemicals known to the State of additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model California to cause cancer, birth defects, and serial numbers of your product ready.
  • Page 2: Table Of Contents

    Contents Safety Introduction ............... 1 This machine has been designed in accordance with Safety ............... 2 ANSI B71.1-2012. General Safety ........... 2 Safety and Instructional Decals ......3 General Safety Setup ................ 5 1 Assembling and Unfolding the Handle....5 This product is capable of amputating hands and 2 Installing the Recoil-starter Rope in the feet and of throwing objects.
  • Page 3: Safety And Instructional Decals

    Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decaloemmarkt Manufacturer's Mark 1. This mark indicates that the blade is identified as a part from the original machine manufacturer.
  • Page 4 decal132-4470 132-4470 Traction Adjustment 1. Attention; read the 2. Scan the QR code for Operator's Manual—1) more information on Loosen the knob by turning traction adjustment. it counterclockwise; 2) Pull the cable(s) away from the engine to decrease the traction, or push the cable(s) toward the engine to increase the traction;...
  • Page 5: Setup

    Setup Important: Remove and discard the protective plastic sheet that covers the engine and any other plastic or wrapping on the machine. Assembling and Unfolding the Handle No Parts Required Procedure Note: Ensure that the cables are routed on the outside of the handle and are not pinched (D of Figure g236451 Figure 3...
  • Page 6: Installing The Recoil-Starter Rope In The Rope Guide

    Installing the Recoil-starter Rope in the Rope Guide No Parts Required Procedure g230719 Figure 4 Filling the Engine with Oil No Parts Required Procedure Important: Your machine does not come with oil in the engine, but it does come with a bottle of oil. Before starting the engine, fill the engine with oil.
  • Page 7: Assembling The Grass Bag

    Assembling the Grass Bag No Parts Required Procedure g230447 Figure 6 Product Overview g036586 Figure 8 1. Grass bag 2. Side-discharge chute Operation Before Operation Before Operation Safety General Safety • g036585 Become familiar with the safe operation of the Figure 7 equipment, operator controls, and safety signs.
  • Page 8: Filling The Fuel Tank

    • the operation of the machine or that the machine Do not store fuel either in the fuel tank or in fuel could throw. containers over the winter unless fuel stabilizer has been added to the fuel. • Adjusting the cutting height may bring you into contact with the moving blade, causing serious •...
  • Page 9: Checking The Engine-Oil Level

    Checking the Engine-Oil Level Service Interval: Before each use or daily Important: If the oil level in the crankcase is too low or too high and you run the engine, you may damage the engine. g222533 Figure 10 Adjusting the Handle Pull the knobs until the square edges of each carriage bolt fits into its related square hole.
  • Page 10: Adjusting The Cutting Height

    Adjusting the Cutting Height CAUTION If the engine has been running, the muffler will be hot and can severely burn you. Keep away from the hot muffler. Adjust the cutting height as desired. Set all wheels to the same cutting height (Figure 12).
  • Page 11: Starting The Engine

    If the grass bag is on the machine and the • Use accessories and attachments approved by bag-on-demand lever is in the bagging position, The Toro® Company only. move the lever to the recycling position; refer to Operating the Bag-on-Demand Lever (page 12). If...
  • Page 12: Bagging The Clippings

    Bagging the Clippings Use the grass bag when you want to collect grass and leaf clippings from the lawn. If the side-discharge chute is on the machine, remove it; refer to Removing the Side-Discharge Chute (page 14). If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to Operating the Bag-on-Demand Lever (page 12).
  • Page 13 g009583 Figure 16 1. Clean here...
  • Page 14: Side-Discharging The Clippings

    – Raise the cutting height on your machine. the cutting season begins. – Cut the grass more frequently. • Replace the blade when necessary with a Toro – Overlap cutting swaths instead of cutting a full replacement blade. swath with each pass.
  • Page 15: After Operation

    After Operation After Operation Safety General Safety • Clean grass and debris from the machine to help prevent fires. Clean up oil or fuel spills. • Allow the engine to cool before storing the machine g033492 Figure 18 in any enclosure. 1.
  • Page 16 g032865 g032869 Figure 21 Figure 19 1. Handle knob 2. Carriage bolt 1. Handle knob 2. Carriage bolt Loosely install the handle knobs and carriage Fold the handle by rotating it forward (Figure 20). bolts on the handle brackets. To unfold the handle, refer to 1 Assembling and Unfolding the Handle (page g032870...
  • Page 17: Maintenance

    Important: Before tipping the machine to genuine Toro replacement parts and accessories. change the oil or replace the blade, allow the Replacement parts and accessories made by fuel tank to run dry through normal usage. If...
  • Page 18: Changing The Engine Oil

    Remove the dipstick by rotating the cap counterclockwise and pulling it out (Figure 24). g031274 Figure 24 1. Dipstick 3. Full 2. Add g033493 Figure 23 Tip the machine onto its side (so that the air filter is up) to drain the used oil from the oil-fill 1.
  • Page 19: Replacing The Blade

    through until the oil level on the dipstick Remove the blade, saving all mounting hardware is correct. (Figure 26). • If the oil level on the dipstick is too high, Install the new blade and all mounting hardware drain the excess oil until the oil level on the (Figure 27).
  • Page 20: Adjusting The Self-Propel Drive

    (Figure 28). On the last refueling of the year, add fuel stabilizer (such as Toro Premium Fuel Treatment) to the fuel as directed on the label. Dispose of any unused fuel properly. Recycle it according to local codes or use it in your automobile.

Table of Contents