Stopping The Engine - Toro Z MASTER G3 Operator's Manual

Figure 18
6. Turn the ignition key to the Start position
(Figure 16). When the engines starts, release the key.
Important: Do not engage starter for more
than 5 seconds at a time. If the engine fails
to start allow a 15 second cool-down period
between attempts. Failure to follow these
instructions can burn out the starter motor.
Note: Additional starting cycles may be required
when starting the engine for the first time after the
fuel system has been without fuel completely.
Figure 19
1. Off
2. Run
G008947
3. Start

Stopping the Engine

Children or bystanders may be injured if they
move or attempt to operate the tractor while it
is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Let the engine idle at slow throttle (turtle) for 60
seconds before turning the ignition switch off.
Important: Make sure that the fuel shut off valve is
closed before transporting or storing the machine,
as fuel leakage may occur. Set the parking brake
before transporting. Make sure to remove the key
as the fuel pump may run and cause the battery
to lose charge.
21
Figure 20