Maintenance; Recommended Maintenance Schedule(S) - Toro 30344 Operator's Manual

Maintenance

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 10 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 1,500 hours
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Maintenance Procedure
• Check and adjust the service brakes.
• Check the tension on the alternator belt.
• Check the tension on the PTO belt.
• Change the hydraulic oil filter. Do not exceed 10 hours or you will damage the
hydraulic system.
• Torque wheel lug nuts.
• Change the engine oil and filter.
• Check and adjust the service brakes.
• Check the tension on the PTO belt.
• Check the engine-oil level.
• Check coolant level.
• Grease the bearings and bushings.
• Check the battery cable connections.
• Check the battery electrolyte level.
• Lubricate the brake cables.
• Change the engine oil and filter.
• Check the torque on the steering-cylinder-mounting bolt (Model 30345 only).
• Check the rear wheel toe-in.
• Inspect the cooling-system hoses.
• Check the tension on the alternator belt.
• Check the condition of and tension on the PTO belt.
• Check PTO clutch gap adjustment.
• Change the hydraulic oil filter.
• Torque wheel lug nuts.
• Grease the transmission bypass pins.
• Grease the rear-axle bearings
• Service the air cleaner.
• Replace the fuel-filter canister.
• Drain and clean the fuel tank
• Inspect the fuel lines and connections.
• Change the rear-axle lubricant.
• Change the bidirectional-clutch lubricant (Model 30345 only).
• Replace any moving hoses.
• Flush and replace the cooling-system fluid.
• Replace the hydraulic oil.
37