Setup; Installing The Handle; Adjusting The Handle Height - Toro 2210 Operator's Manual

Setup

1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the 2 bolts from the machine frame in the
location shown in Figure
1. Bolt (2)
2. Rotate the handle rearward to the operating position.
3. Secure the handle to the machine with the bolts that
you removed in step
4. Tighten the fasteners that support the handle on both
sides of the machine as shown in
3.
2
1
G019802
Figure 3
2. Nut on handle support
bracket (2)
1
Figure 4.
1
1. Cable tie
2. Nut on handle support
bracket (2)
5. Use a cable tie to secure the cables to the lower handle
in the location shown in
6. Secure the cable tie on the handle and trim off the
excess material from the tie.
2

Adjusting the Handle Height

No Parts Required
Procedure
1. Stand in the operating position to determine the most
comfortable handle height.
2. Remove the handle bolt and insert it in 1 of the 3 holes
located at the bottom of the handle bracket
5
2
3
G027930
Figure 4
3. Bolt (4)
Figure 4.
(Figure 5).