Preparing The Engine; Removing The Machine From Storage - Toro 2210 Operator's Manual

Preparing the Engine

1. While the engine is still warm, change the engine oil
and the oil filter; refer to
(page 17) and Changing the Oil Filter (page
2. Remove the spark plug.
3. Using an oil can, add about 30 ml (1 oz), of motor oil
to the engine through the spark-plug hole.
4. Slowly pull the starter rope several times to distribute
oil throughout the cylinder.
5. Install the spark plug but do not connect the wire to
the spark plug. Secure the wire so that it does not come
into contact with the spark plug.
Removing the Machine from
Storage
1. Check and tighten all fasteners.
2. Remove the spark plug and spin the engine rapidly
using the starter to blow excess oil from the cylinder.
3. Inspect the spark plug and replace it if it is dirty, worn,
or cracked; refer to the engine owner's manual.
4. Install the spark plug and tighten it to the recommended
torque of 20 N-m (180 in-lb).
5. Perform any needed maintenance procedures; refer to
Maintenance (page
6. Check the engine-oil level; refer to
Engine-Oil Level (page
7. Fill the fuel tank with fresh gasoline; refer to
the Fuel Tank (page
8. Connect the wire to the spark plug.
Changing the Engine Oil
18).
16).
Checking the
9).
10).
Filling
26