Adjusting The Self-Propel Cable - Toro 2210 Operator's Manual

Figure 40
1. BBC belt
7. Remove the BBC belt from the brake-drum pulley.
8. Move the tab forward
Note: The tab prevents the transmission from tipping
to the point where the transmission belt comes off.
1
Figure 41
1. Transmission tension
spring
2. Transmission
3. BBC belt
9. Remove the transmission tension spring.
10. Remove the transmission belt from the transmission
pulley.
11. Remove the BBC belt.
Note: Hold one of the blades using a glove or a rag
and turn the blade spindle to help remove the BBC belt.
12. To install a new BBC belt, reverse the steps above.
G019899
2. BBC belt guard
(Figure 41).
2
3
G019898
4. Transmission belt
5. Tab
13. Adjust the BBC cable; refer to
Blade-Brake Cable (page
Adjusting the Self-Propel
Cable
1
If the machine does not self-propel or tends to creep forward
when you release the control bar, adjust the drive cable.
1. Stop the engine and wait for all moving parts to stop.
2. Loosen the cable support nut
2
3. Pull down the cable jacket (toward the mower) until
there is no slack in the cable
4
5
4. Tighten the nut on the cable support.
5. Check the operation for desired drive control.
Note: If the unit creeps forward without the bail engaged
or if the wheels spin when you lift the rear wheels off the
ground, the cable is too tight; repeat
Note: Adjustment to obtain desired ground speed at full bail
travel may be made in order to accommodate slower speeds.
23
Adjusting the
24).
(Figure 42).
Figure 42
(Figure 43).
Figure 43
steps1 and 2.