Maintenance; Recommended Maintenance Schedule(S); Maintenance Safety; Servicing The Air Filter - Toro 2210 Operator's Manual

Maintenance

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 250 hours
Every 300 hours
Yearly or before storage
Important: Refer to your engine owner's manual for additional maintenance procedures.

Maintenance Safety

•
Disconnect the spark-plug wire from the spark plug before performing any maintenance procedure.
•
Wear gloves and eye protection when servicing the machine.
•
The blade is sharp; contacting the blade can result in serious personal injury. Wear gloves when servicing the blade.
•
Never tamper with safety devices. Check their proper operation regularly.
•
Tipping the machine may cause the fuel to leak. Fuel is flammable and explosive, and can cause personal injury. Run the
engine dry to remove the fuel with a hand pump; never siphon the fuel.

Servicing the Air Filter

Service Interval: Before each use or daily
Every 25 hours—Clean the foam pre-cleaner (more
frequently in dusty conditions).
Every 300 hours—Replace the paper air filter (more
frequently in dusty conditions).
Important: Do not operate the engine without the air
filter assembly; extreme engine damage will occur.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug.
3. Remove the cover and clean it thoroughly
Maintenance Procedure
• Change the engine oil without the oil filter.
• Service the blade-drive system.
• Check the engine-oil level.
• Check the blade-stop system operation. The blades should stop within 3 seconds of
releasing the control bar; if they do not, contact an Authorized Service Dealer.
• Clean under the machine housing.
• Inspect the air filter.
• Check the cutting blades and service them, if necessary.
• Inspect the blades.
• Clean the foam pre-cleaner (more frequently in dusty conditions).
• Change the engine oil (more often in dusty conditions).
• Check the condition of the belts.
• Check the fuel hose and replace it if necessary.
• Remove debris from under the belt cover.
• Service the blade-drive system.
• Change the oil filter.
• Check the spark plug.
• Clean the fuel tank filter.
• Change the fuel filter.
• Change the blade-brake-clutch belt.
• Replace the paper air filter (more frequently in dusty conditions).
• Empty the fuel tank before repairs as director or before storage.
(Figure 26).
16