M.T.H. HO 4-6-6-4 Challenger Engineer's Manual page 3

QUICK START GUIDE
Of course, you should read your manual over before running your Steam
Engine. But if you just can't wait, choose how you want to run below and
enjoy!! It is important to pay attention to which model you have purchased
and to make sure you are following the proper instructions for your Engine.
I USE A REGULAR DC SUPPLY...
Step 1: Unpack your engine (refer to unpacking instructions on pg 4)...
Step 2: Set the engine on the track ...
Step 3: Apply increasing DC voltage until she starts up and pulls out!
I'M A DCC OPERATOR....
Step 1: Unpack your engine (refer to unpacking instructions on pg 4)...
Step 2: Set the engine on the track ...
Step 3: Power up your DCC system...
Step 4: Select engine address 3 and press "F3" to start her up...
Step 5: Turn the throttle and head on down the pike...
I RUN DCS....
Step 1: Unpack your engine (refer to unpacking instructions on pg 4)...
Set the engine on the track ...
Step 2:
Step 3: Power up your DCS system...
Step 4: Add the engine to your system and start her up...
Step 5: Turn the throttle and move out....
M.T.H. HO 4-6-6-4 Challenger Steam Engine
3