Operation; To Process Product - BIRO 3334 Operating And Service Manual

SHARP MOVING BAND TYPE SAW BLADE
ONLY Properly Trained Personnel Should Use This Equipment.
ALWAYS Keep Hands Clear of Band Type Saw Blade and Other Moving Parts.
NEVER Operate with Saw Guard on Saw Guide Bar in the Raised Position or the Saw Guard
Removed from the Saw Guide Bar.
ALWAYS Adjust the Saw Guide Bar with Saw Guard to Within
ALWAYS Use Safety End Cut Pusher Plate for Smaller Products or The Last Cuts of Product.
DO NOT Wear Gloves While Operating.
DO NOT Tamper With, Bypass, Alter, or Modify this Equipment in Any Way From Its Original
Condition.
ALWAYS Turn Off, Unplug from Power Source and Perform Lockout/Tag Out Procedures Before
Cleaning, Servicing or When Not in Use.
NEVER Leave Unattended While Operating.
NEVER Operate Without All Warnings Attached and Wall Chart Posted.
A. TO PROCESS PRODUCT
1. Before starting power cutter, adjust saw guide bar with saw guard down to within ½² (13 mm) of product to
be cut.

OPERATION

TO AVOID SERIOUS PERSONAL INJURY
" of Product to be Cut.
1
2
6