Belkin Conserve User Manual page 2

Connecting your equipment
The Conserve surge protector has eight (8) outlets. The outlets marked "Always On Outlets"
are always powered when the surge protector is plugged in. They are not switchable. These
outlets are intended for use with devices that typically need to stay on at all times. The
outlets labelled "Remote Switched Outlets" are controlled via the wireless remote switch.
Using the Wireless Remote Switch
An A23 (12V) alkaline battery is included. Before using the wireless remote switch for the
first time, simply remove the battery security tab from the switch. Now the switch is ready.
A green LED on the wireless remote switch will illuminate when the switch is pressed. This
indicates that the signal was sent and that the battery is OK. Conserve has a range of up to
20mt.* Line of sight from the wireless remote switch to the surge protector is not required.
If you do not see the light, it is time to replace the battery. To replace the
battery, remove the battery cover from the back of the wireless remote
switch and replace the battery with an A23 (12V) alkaline battery.
*Actual range may vary depending on interference, building materials (e.g.,
masonry, metal walls), and other location-specific conditions.
3. Installation & Mounting
The Wireless Remote Switch with Wall-Mount
Use either the adhesive tape or screws (not included) to attach the wall bracket securely
to a wall. Ideally, place the wireless remote switch near existing light switches or the
entrance to a room for added convenience and accessibility. The wireless remote switch
can also be kept conveniently anywhere (e.g., by a bed, on a coffee table, on a desk).
The Surge Protector
(Optional) Use the two mounting holes on the back of the surge protector
to secure it to the wall or baseboard. Install two screws (not included),
leaving at least 6mm of the screw exposed. Insert the screws into the
mounting holes of the surge protector and lock into place.
Use the detachable cable-management system (included)
to help route and organize cables.
4. Safety Information
• T o reduce the risk of electrical shock, unplug the
unit and allow it to cool before cleaning.
• D o not "daisy-chain" this product or use it with extension cords.
The Belkin Conserve's power cord must be plugged directly into
an AC power source to ensure proper surge protection.
• F or indoor use and in dry locations only. Not for use with
aquariums or other water-related products.
5. Technical Information
PLEASE SEE PRODUCT BACK PLATE FOR MORE INFORMATION.
Our product conforms to the R&TTE Directive 1999/5/EC.
A Copy of the European Union CE marking "Declaration of Conformity"
may be obtained at the website: www.belkin.com/doc.
FCC ID: K7S-BG200001
FOR HOME OR
OFFICE USE
Belkin Ltd.
+44 (0) 1933 35 2000
Rushden, United Kingdom
Belkin B.V.
+31 (0) 20 654 7300
Schiphol-Rijk, Netherlands
www.belkin.com
© 2009 Belkin International, Inc. All rights reserved. All trade names are registered trademarks of respective manufacturers listed.
8820-00127cr_BG108000cr2M_QIG.indb 2
Belkin SAS
+33 (0) 1 41 03 14 40
Boulogne-Billancourt, France
Belkin Iberia
+34 91 791 23 00
Alcobendas, Spain
Enlish
Belkin GmbH
+49 (0) 89 143405 0
Munich, Germany
Belkin Italy & Greece
+39 02 862 719
Milano, Italy
8820-00127cr
BG108000cx2M
•
19/03/2010 10:15:42