Cycle And Option Descriptions - Whirlpool wdf540padw1 User Instructions

NOTE: For m ost w ater conditions, the factory s etting w ill g ive good
results.
• Check water hardness level to ensure no rings or spots on your
dishware before adding rinse aid or adjusting the factory
setting.
setting.
Turn the arrow adjuster inside the
dispenser by either using your fingers or
inserting a flat-blade screwdriver into
the center of the arrow and turning.
If you have hard water or notice rings or spots, try a higher
STEP3
Select a Cycle (cycles vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
Heavier cycles and options affect cycle length.
Sensor Heavy Normal I-Hour Soak&
Wash Clean
oOO ........
,o
i Cycles
• ,°, ..... ,.o
Select Options (options vary by model)
See "Cycle and Option Descriptions" charts in the following
section.
You can customize your cycles by pressing the options desired.
Start
hold 3 sec Resume
Oo°,,,,o°,,.,.° ...... oooooo.,,ooo.,° ............ °,o ooO-OO,°°
Sani Heat Hi Temp Target _ .,'° _'% "_c .... l/Drain
Rinse Dry Wash Clean :"; D/ : hold3sec
. ," :
.o.°.° ..... °,,°°o,,°°°°°°,,,,,°oo .............. oO ",°,°°o,
STEP4
Start or Resume a Cycle
• Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water. For best dishwashing results, water
should be 120°F (49°C) as it enters the dishwasher.
• For models with controls on top of the door, select wash cycle,
option and press START/RESUME before closing the door.
Push door firmly closed. The door latches automatically. Select
the wash cycle, options and press STAR/RESUME or press
START/RESUME to repeat the same cycle and options as in the
previous wash cycle.
Start
Resume
o•°°°°.°
; "°
; [_ }C .... l/Drain
hold 3 sec
". .. :
Oo.oo,°
• You can add an item anytime at the beginning of the cycle.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.