NPK PH1 Operator's Manual page 52

TOOLS
CHANGING THE TOOL
TOOL REMOVAL
6. Remove the tool (HH).
TOOL INSTALLATION
1. Clean the retaining pin bore.
2. Coat the surface of the tool (HH) with
grease, then install.
3. Coat the retaining pin (D) with grease, then install.
4. Install the retaining pin ring (E) by using the handle of a screwdriver (t22) as shown
in Figure 9.
Figure 8
5. Install the retaining pin stopper plate
(GK). Torque bolts (OO) to 85 ft. lbs.
(115 Nm).
Figure 6
Figure 7
Figure 9
Figure 10
- 51 -