LUBRICATION
AUTO LUBE GREASE LINE PRE-FILLING
It is mandatory that the supply line from the Auto Lube main pump to the connection on
the hammer is primed with grease before it is used. Failure to do this will result in no
grease being administered to the hammer tool for two to three hours. This can and will
result in severe galling of the tool and tool bushing.
PRIMING THE GREASE LINE
1. Place the hammer (KK) in a vertical position, applying enough down force to push
the tool up into the hammer.
2. Turn the machine off.
3. Fill the NPK Auto Lube pump reservoir with a power greaser through the fill fitting on
the side of the pump, or from the top by removing the fill cover. Use a premium
quality grade EP-2, high temperature grease with wear inhibiting additive.
4. Disconnect the grease line (29) from
the Auto Lube main pump cartridge
(a4).
5. Install part number G100-8050 hose fill
adapter (a13) onto the #6 JIC end of
the
grease
line
removed.
6. Remove the grease line (29) at the
hammer (KK).
7. Attach a grease gun (t37) or power
greaser to the grease line (29) leading
to the hammer.
(29)
previously
- 20 -