Table of Contents
Advertisement
OPERATION
OPERATING TECHNIQUES & PRECAUTIONS
DO NOT USE THE HAMMER
TOOL AS A PRY BAR
Excessive prying can cause premature
bushing wear and tool or tie rod
breakage. When hammering materials
that allow the tool to penetrate before
breaking, move the hammer slightly
fore and aft to create a cone-shaped
hole. The vented hole allows trapped
dust and heat to escape, increases the
tool penetration rate into the material,
and prevents overheating the tool tip.
DO NOT HAMMER CONTINU-
OUSLY
IN
THE
SAME
POSITION FOR MORE THAN 30
SECONDS
If the tool cannot break or penetrate
into the material after hammering in the
same position for 30 seconds, change
the working location. Hammering in the
same position for a long time will
reduce the working efficiency, increase
the hydraulic oil temperature, overheat
the tool tip and accelerate tool wear.
ALWAYS WORK BY BREAKING
TO A FREE FACE
The material must have somewhere to
break. Start at an edge.
- 33 -
Hide quick links:
Advertisement
Table of Contents
