Fm Radio Mode; Tuning To An Fm Station; Changing The Scan Setting - DIGITAL RADIO MAGICBOX Manual

Using the FM Radio

FM Radio Mode

When your radio is in FM mode it can receive Radio Data
System or 'RDS' information if this is being transmitted by the
broadcaster�� RDS information will often include the station
name, detail about the programme and the current time��
If you were listening to an FM station when you switched the
radio off then this station will be automatically selected when
you switch the radio back on��
Telescopic aerial
Please make sure that the aerial on the back of the radio is
fully extended and adjusted before you attempt to tune to
an FM station (a vertical position is recommended)�� This will
ensure that the maximum signal strength is available when
the radio begins to scan�� Extending the aerial also ensures
the best possible sound quality��

Tuning to an FM station

1�� If you are not already in FM mode, press the 'Mode' button to
go to FM mode��
�� Press and release the 'Scan' button on the front of your radio
to scan up the frequency band�� Press and hold 'Scan' to scan
down the frequency band�� Your radio will search for the next
available station and then stop on that station��
3�� Use the or button to fine tune each frequency in
0��05MHz steps��
The RDS information for each station will be displayed, if
available��
Note: If reception is still poor adjust the position of the aerial
or try moving the radio to another location��

Changing the Scan setting

In FM mode:
1�� Press the 'Menu' button�� 'Scan setting' is displayed�� Press
'Enter' �� There are now two different options to choose from:
Strong stations - the scan will only stop when a strong
signal strength is received which should also result in a better
audio quality�� It is possible that the station you are scanning
for may be missed using this option��
All stations - the scan will stop for every station it receives,
even if the signal strength is poor��
10