Checking The Engine Oil Level; Adjusting The Cutting Height - Toro 20837 Operator's Manual

Checking the Engine Oil Level

Service Interval: Before each use or daily—Check the engine
oil level.
Note: Max. fill: (0.55 l) 0.58 quart, type: SAE 30 detergent
oil with an API service classification of SF, SG, SH, SJ, SL,
or higher.
1. Move the machine to a level surface.
2. Remove the dipstick (Figure 10).
3. Wipe off the dipstick end with a clean cloth.
4. Insert the dipstick into the oil-fill tube, but do not
screw it in.
Figure 9
Figure 10
5. Remove the dipstick and read the oil level on the
dipstick (Figure 10).
•
If the oil level is too low, add a small amount of
oil slowly to the oil-fill tube, and then repeat steps
3 through 5 until the oil level on the dipstick is
correct.
•
If the oil level is too high, drain the excess
oil until the oil level on the dipstick is
correct. To drain the excess oil, refer to
Changing the Engine Oil (page 13).
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick securely.

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired.
Note: To raise the machine, move both cutting-height
levers forward; to lower the machine, move them rearward
(Figure 11).
1. Cutting-height lever
8
Figure 11