Setup; Unfolding The Handle; Installing The Blade-Control Bar; Installing The Recoil-Starter Rope In The Rope Guide - Toro 20837 Operator's Manual

Setup

1

Unfolding the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Loosen the handle knobs (Figure 3).
1. Handle knobs
2. Carefully move the upper handle forward until the
handle halves are in line and nest together as shown
in Figure 4.
3. Tighten the handle knobs firmly by hand.
G020721
Figure 3
G020722
Figure 4
4. Rotate the handle rearward to the operating position,
and lock the handle at your desired height. Refer to
Adjusting the Handle Height (page 9).
2
Installing the Blade-control
Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle (Figure 5).
3
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: You must install the recoil-starter rope in
the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 6).
5
Figure 5