Recycling The Clippings; Installing The Grass Bag; Bagging The Clippings - Toro 20837 Operator's Manual

Figure 16

Recycling the Clippings

Your machine comes from the factory ready to recycle the
grass and leaf clippings back into the lawn.
Note: The grass bag may remain on the machine while you
are recycling the clippings.
To recycle the clippings, move the bag-on-demand lever to
the recycling mode (Figure 17).
Figure 17
1. Recycling mode

Bagging the Clippings

Use the grass bag when you want to collect grass and leaf
clippings from the lawn.
WARNING
A worn grass bag could allow small stones and other
similar debris to be thrown toward the operator or
a bystander and result in serious personal injury or
death.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.
1. Stop the engine and wait for all moving parts to stop.
2. Install the grass bag; refer to
Removing the Grass Bag (page 10) and move the
bag-on-demand lever to the bagging mode (Figure 18).
1. Bagging mode

Installing the Grass Bag

1. Stop the engine and wait for all moving parts to stop.
2. Raise and hold up the rear door, install the bag in the
notches, and lower the rear door (Figure 19).
Removing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Lift up the grass bag up and away from the handle.
Note: Tilt the grass bag slightly backward to prevent
the collected grass clippings from falling out.
10
Figure 18
Figure 19